13
Method :
E
LECTRO
V
AP
KIT MC
Installation - Step 1
Pick up the supplied drilling template and lay it
flat against the wall where the humidifier
should be installed paying care of the
measures.
The small KIT MC 5 to 30 requires 8 drilling
marks while the large KIT MC 40 to 60
requires 16 drilling marks. For the large kit,
mark the first eight drilling marks, trace the
template corners and then report the drilling
template to the right side aligning the corners.
Mark the eight drilling marks anew.
Drill holes at the drilling marks, insert pegs
appropriate to the support.
Any loss or damage during delivery should be reported to carrier by registered letter within 3
working days and be advised to
devatec
or to authorized dealer.
Unpack the humidifier from its carton box, take the steam cylinder off the bracket and lay it gen-
tly on ground and attach the humidifier bracket on the the wall as per the following :procedure :
Take the upper bracket and fix it with a screw
(as per in 1 on the attached drawing). Level
the bracket with a bubble level and screw up
the other three screws.
Take care : KIT MC 40 to 60 requires that two
upper brackets be wall installed and secured
by 8 screws.
Take the lower bracket, install it on wall with
screws 2 & 3 as per attached drawing. Control
vertical alignment and distance H (s.a. pages
12-13) and screw up the 4 screws.
Take care : KIT MC 40 to 60 requires that two
lower brackets be wall installed and secured
by 8 screws.
1
H
1
2
3
