ElectroVap®
ELMC-SB
36
FOAM / SCALE
CONTROL XX sec
POWER OFF IF
DRAINING:
Xxx
VALUE: between 0 and 10 seconds
Allows you to set the time for a small drain. If there is
foam inside the cylinder, increase the time. This foam
phenomenon usually appears with softened water
VALUE: YES or NO
Cuts the contactor(s) during a drain and avoids leakage
currents
ADJUST STEAM BY:
XXXXXXXXXX
VALUE:
EVAPORATION
(necessary for demineralized
water) or
DRAINING
CYLINDER SELECT
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
XXXXX
IDENTIFICATION
OF ELMC XX
VALUE: CLEANABLE(EV), CLEANABLE (EA), CLEANABLE
(ED).
EV: Tap water, EA: softened water, ED: demineralized
water
VALUE between 1 and 32:
Identifies humidification when
it is connected to a communication Modbus
PROTOCOL
NETWORK
SPEED DATA
XXXXb/s
VALUE: MODBUS RTU 8-N-1, MODBUS RTU 8-N-2,
BACNET MS/TP
VALUE: 1200/2400/4800/9600 b/s:
Syncs the speed of
communication between the ELMC and the
communication system
SETTING TEMP
WATER 65°C: XXX
VALUE: NO:
Not used with Steam Bath generator
DRAINING AFTER
SHUT DOWN?
Xxx
Value: YES or NO
DRAINING AFTER Xxx
HRS
Value: between 1 and 72 hours
If the end-of-season drain is active
BACK TO THE BEGINNING
Summary of Contents for ElectroVap ELMC 20-30 SB
