Wiring must be done in a manner that the full
Motor nameplate v/- 10% is available at
the Motor terminals during startup.
The Warranty that exists on the Electric Motor is
that of the
original manufacturer
. In the event of
a Motor failure, contact your Devair Distributor or
Service Centre for the location of the nearest
authorized Motor Service Centre.
To ensure that your new Devair Compressor will
work when required, you must ensure that it is
correctly wired to your building service. It is the
responsibility of the licenced Electrician to ensure
that:
A) the Unit that you have purchased is suitable for
your particular buildings electrical service.
B) protective devices such as a Magnetic Starter,
Fused Disconnect, etc. have been sized and
installed correctly.
C) any electrical accessories purchased with your
Compressor have been wired correctly
D) the wiring of the Unit meets with all applicable
codes and regulations.
E) when completed, the Unit works in both a safe
and correct manner.
Failure of the Compressor due to an incorrect
electrical installation is not covered by the
manufacturers warranty.
Use of an incorrect Electric Motor for
your particular building service will
result in premature Motor failure, and
is not covered by the Devair or Motor
manufacturer's Warranty.
NOTE
Installation - Electrical (cont’d)
Motors
Pump Rotation
Why hire a licensed Electrician?
The Compressor is to be wired in a manner that
the rotation of the Flywheel causes the air to be
blown from the Flywheel forward over the Pump.
This, coupled with the free area of a minimum of
18” (0.5 m) behind the Beltguard, allows the
Pump to cool properly.
When facing the nameplate
side of the Unit, the
Flywheel rotation must be
clockwise.
- 12 -
HDI-01
Mar ‘07
Distributed by: CENTRAIR Air Systems & Supplies, 68 Hooper Rd., Unit 5, Barrie, ON L4N 8Z9
Phone: 705-722-5747 Fax: 705-722-5458 [email protected] www.centrair.ca
All manuals and user guides at all-guides.com
