Dettson AMT100B34-IM2, Installation Instructions Manual

Page: 3 / 50

3
PART 1 INSTALLATION
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR OTHER
FLAMMABLE VAPORS AND LIQUIDS IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCE.
DO NOT ATTEMPT TO START THE BURNER WHEN
EXCESS OIL HAS ACCUMULATED, WHEN THE
FURNACE IS FULL OF VAPOUR OR WHEN THE
COMBUSTION CHAMBER IS VERY HOT.
1.1) DANGER, WARNING AND CAUTION
The words DANGER, WARNING and CAUTION are used to identify the
levels of seriousness of certain hazards. It is important that you
understand their meaning. You will notice these words in the manual as
follows:
DANGER
Immediate hazards which WILL result in death or
serious bodily and/or material damage.
WARNING
Hazards or unsafe practices which CAN result
in death or serious bodily and/or material
damage.
CAUTION
Hazards or unsafe practices which CAN result in
minor bodily and/or material damage.
1.2) SAFETY INSTALLATION REQUIREMENTS
WARNING
For use with grade 2 fuel oil maximum. Do NOT
use gasoline, crankcase oil or any oil containing
gasoline.
WARNING
Never burn garbage or paper in the heating system
and never leave rags or paper around the unit.
CAUTION
ENVIRONMENTAL HAZARD – Failure to follow
this caution may result in environmental pollution.
Remove and recycle all components or materials
(i.e. oil, electrical and electronic components,
insulation, etc.) before unit final disposal.
CAUTION
These instructions are intended for the sole use of
qualified personnel trained in installing this type of
furnace. Installation of this furnace by an
unqualified person can lead to hazardous
conditions, resulting in bodily harm and/or
equipment damage.
IMPORTANT: For the installation of the sidewall vent of
the Sealed Combustion System, refer to the VTK
Instruction Manual (X40142).
IMPORTANT : All local and national code requirements
governing the installation of oil burning equipment, wiring
and flue connections MUST be followed. Some of the
codes that may be applicable are:
CSA B139 Installation code for oil burning
equipment
NFPA 31 Installation of oil burning equipment
ANSI/NFPA 90B Warm air heating and air conditioning
systems
ANSI/NFPA 211 Chimneys, fireplaces, vents and solid
fuel burning appliances
ANSI/NFPA 70 National electrical code
CSA C22.1 Canadian electrical code
Only the latest issues of the above codes should be
used, and are available from either:
The National Fire Protection Agency
Batterymarch Park
Quincy, MA 02269
or
The Canadian Standards Association
178 Rexdale Blvd.
Rexdale, Ontario
M9W 1R3