MBE 900 OPERATOR'S MANUAL
NOTICE:
Keep the engine running at idling
speed until an oil pressure reading is
obtained. If no oil pressure is shown
after approximately 10 seconds,
stop the engine and determine the
cause. Failure to do so could result
in engine damage.
11. Start the engine with the
accelerator pedal in the idle
position. Monitor the oil pressure
gauge.
12. Check the
fi
lter and oil drain plug
for signs of leakage.
13. Stop the engine.
14. Check the oil level again after
approximately
fi
ve minutes.
If necessary, add oil up to the
maximum
fi
ll level on the oil
dipstick. Do not over
fi
ll.
Oil Centrifuge
The MBE six-cylinder engines
(906/926) have an oil centrifuge.
NOTICE:
Both the primary lube oil filter (front
of engine) and the oil centriguge
cartridge (side of engine) must be
replaced at each oil drain interval.
Change the oil centrifuge cartridge as
follows:
1. Remove the cover of the oil
centrifuge. See Figure 48.
Figure 48 Oil Centrifuge
2. Lift out the dirty cartridge and
replace it with a clean one
(see Figure 49).
Figure 49 Centrifuge Cartridge
3. Replace the centrifuge cover,
tighten the cap 40 Nm (30 lb·ft).
All information subject to change without notice.
(Rev. )
89
DDC-SVC-MAN-0055
Copyright © 2009 DETROIT DIESEL CORPORATION
Summary of Contents for EPA04 MBE 900
Page 2: ......
