Detnov CCD-020, Installation Manual

Page: 17 / 40

17
EN
3.2. Installation steps
3.2.1. Removing the front cover
To access the inside of the control
panel, remove the 2 screws from
the front part in the lower area.
After unscrewing them, remove
the cover.
3.2.2. The control panel's wiring
Before mounting the control panel, establish where the necessary wires will pass through
(the lines for the zones, sounders and connection to the mains supply).
The sounder and zone lines should
be connected via the right side of
the case (A), either by making
holes at the top using a crown
drill bit (drill the necessary holes
and use PG13 cable glands) or by
breaking through the rear wall.
Use the openings on the left side
of the case to feed in the wires for
the mains supply, either through
the opening at the top (B) or the
hole at the back (C).
A
B
C
CAUTION:
Be careful when drilling the housing to make a hole
for the lines, you may damage the control panel's electronics.