Detnov CCD-020, Installation Manual

Page: 11 / 40

11
EN
1.6. Damage to the unit
If the unit is damaged, any accessory is missing or you have queries regarding the
explanations in this manual:
• Contact your technical support service or distributor. If necessary, they will send you
a document to manage your RMA request.
• Note down the invoice or delivery note number and whether the unit is still under
warranty.
• Note down all of the relevant details in your RMA request: date of receipt of the
product, detailed description of the fault, condition of the packaging, etc., and send it
to your supplier.
• If you need to send the product to your supplier, use the original packaging, where
possible.
1.7. Requirements
1.7.1. Assembly notes
KNOWLEDGE: Make sure that you have the necessary mechanical and electrical
knowledge of fire detection systems to install this control panel and connect it to the
detection system and mains supply.
TOOLS: To assemble the control panel, you will need:
• An electric drill
• A cross-head screwdriver (Phillips or Pozidrive)
• A small flat-head screwdriver for the terminals
• Insulating tape
• Measuring tape
• A cutter
• 4 lag screws, 3.6-4.1 mm in diameter and 40 mm long
• 4 DNP6 wall plugs (6 mm in diameter)
• A multimeter
• PG13 cable glands (the quantity necessary for the number of outputs/inputs that are
going to be used)
• A crown drill bit with a diameter of 18 mm