Programming Manual
Conditioner CDT-404-2 / Touchscreen ETC1
English
Page 8/24
PROG404CDT-404-2-EN – Index B
Control
:
When 2 controls are set, it is possible to perform them in 2 ways :
Associated
and
Dissociated
.
The
Associated
parameter allows the controls to be continuously, one after the other, from
the top control. At the top control, the detector goes to the left on the first tool and then
without stopping by right on the second tool to eventually return to the origin.
The
Dissociated
parameter allows at the top control to perform the first control on the left
and return to the origin to wait a second top control that will make the second control on
the right with return to the origin at the end.
Note :
This parameter only appears if the «
Number of control
» parameter is
2
.
Number of control
:
It is possible to position the detector between two tools which have substantially the same
position (same tool exit length) and to carry out the control of the first tool in one direction
and the control of the second tool in the other direction
.
The choice of the number of control may be 1 or 2
Note:
In the case of a parameterization of 2 controls, the "direction of rotation" to be
specified in the above parameter defines the direction of the first control.
