DeskBook B165, User Manual

Page: 91 / 108

79
HARD DISK INSTALL
FAILURE Cannot find or initialize the hard drive controller or the
drive. Make sure the controller is installed correctly. If no
hard drives are installed, be sure the Hard Drive selection
in Setup is set to NONE.
Hard disk(s) diagnosis fail The system may run specific disk diagnostic routines.
This message appears if one or more hard disks return an
error when the diagnostics run.
Keyboard error or no
keyboard present Cannot initialize the keyboard. Make sure the keyboard is
attached correctly and no keys are pressed during POST.
To purposely configure the system without a keyboard,
set the error halt condition in Setup to HALT ON ALL,
BUT KEYBOARD. The BIOS then ignores the missing
keyboard during POST.
Keyboard is locked out -
Unlock the key This message usually indicates that one or more keys
have been pressed during the keyboard tests. Be sure no
objects are resting on the keyboard.
Memory Test: This message displays during a full memory test, counting
down the memory areas being tested.
Memory test fail If POST detects an error during memory testing,
additional information appears giving specifics about the
type and location of the memory error.
Override enabled - Defaults
loaded If the system cannot boot using the current CMOS
configuration, the BIOS can override the current
configuration with a set of BIOS defaults designed for the
most stable, minimal-performance system operations.
Press TAB to show POST
screen System OEMs may replace the Phoenix Technologies’
Award BIOS POST display with their own proprietary
display. Including this message in the OEM display
permits the operator to switch between the OEM display
and the default POST display.
Primary master hard disk
fail POST detects an error in the primary master IDE hard
drive.
Primary slave hard disk fail POST detects an error in the primary slave IDE hard
drive.
Error Messages Corrective Action
Jaguar2-e.book Page 79 Tuesday, June 17, 2003 5:27 PM