![background image](http://html1.mh-extra.com/html/desa/comfort-glow-brentwood-lcf18/comfort-glow-brentwood-lcf18_owners-operation-and-installation-manual_2486300015.webp)
www.desatech.com
115043-01C
15
TROUBLESHOOTING
Continued
POSSIBLE CAUSE
1. Metal expanding while heating
or contracting while cooling
1. Log Set burning vapors from
paint, hair spray, glues, clean-
ers, chemicals, new carpet,
etc. (See
IMPORTANT
state-
ment above)
2. Gas leak.
See Warning
statement at top of page
1. Gas leak.
See Warning
statement at top of page
2. Control valve defective
1. Gas leak.
See Warning
statement at top of page
OBSERVED PROBLEM
Log Set produces a clicking/tick-
ing noise just after burner is lit
or shut off
Log Set produces unwanted
odors
Gas odor even when control knob
is in OFF position
Gas odor during combustion
REMEDY
1. This is common with most log
sets. If noise is excessive, con-
tact qualified service person
1. Open flue to maximum. Stop
using odor causing products
while log set is running
2. Locate and correct all leaks
(see
Checking Gas Connec-
tions
, page 7)
1. Locate and correct all leaks
(see
Checking Gas Connec-
tions
, page 7)
2. Replace control valve
1. Locate and correct all leaks
(see
Checking Gas Connec-
tions
, page 7)
WARNING: If you smell gas
• Shut off gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor’s phone. Fol-
low the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
IMPORTANT:
Operating log set where impurities in air exist may create odors. Cleaning supplies, paint,
paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These
fumes may mix with combustion air and create odors. These odors will disappear over time.