![background image](http://html.mh-extra.com/html/desa/cdcfnra/cdcfnra_owners-operation-and-installation-manual_2486270016.webp)
www.desatech.com
123502-01C
16
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
(HRC100 Series & HRC200 Series)
Installing Receiver
1. Disconnect jumper wires from the control
valve (see Figure 20).
2. Locate the battery clip mounted on the
back of the receiver (see Figure 21).
3. Slide 9-volt battery (not included) through
the clip.
4. Attach the terminal wires to the battery
(see Figure 21).
5. Connect wires from remote receiver to
control valve as shown in Figure 22.
6. Install remote receiver unit onto remote/
blower bracket using screws provided
(see Figure 22).
Installing 9-volt battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery (not
included). Place battery into the battery
housing.
3. Replace battery cover onto remote control
unit.
iNsTallaTioN
Continued
Figure 20 - Disconnecting Jumper Wires
From Control Valve
Figure 21 - Attaching Battery to Receiver
Battery Clip
9-Volt
Battery
Receiver
Terminal
Wires
Figure 22 - Installing Remote Receiver
Remote
Receiver
White Wire to
TH Terminal on
Control Valve
Red Wire to
TPTH Terminal on
Control Valve
OPTIONAL WALL MOUNTED
THERMOSTAT - GWMT1
(Remote-Ready Models Only)
WARNING: Read and fol-
low installation instructions.
Installation should be done by
a qualified installer familiar with
low-voltage wiring procedures.
WARNING: Do not connect
this thermostat to any electrical
source! Electrical shock and/or
fire hazard will occur.
1. Remove jumper wire from control valve
(see Figure 20).
2. Connect one terminal of 25 ft. wire to
the “TH” terminal on the control valve.
Connect the other terminal to the “THTP”
terminal on the control valve. See Figure
24, page 17.
3. Route the 25 ft. wire to a convenient loca
-
tion to mount your thermostat (no outside
wall).
IMPORTANT:
The wire may be
shortened but must not be lengthened.
The thermostat should be mounted 54"
above the floor in a location where there
is good air circulation. Avoid heat sources
such as lamps, direct sunlight, fireplace
or heat and air conditioning ducts.
9-Volt Battery
Battery
Housing
Figure 23 - Installing Battery in Hand-
Held Remote Control Unit
Battery Cover
Terminal
Wires
Remote Control Unit