www.desatech.com
123502-01C
19
iNsTallaTioN
Continued
opERaTioN
THERmosTaT-CoNTRollED moDEls
hand, don’t try to repair it, call a quali
-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
WARNING: You must operate
this fireplace with the screen
in place. Make sure fireplace
screen is installed before run-
ning fireplace.
NOTICE: During initial operation
of new fireplace, burning logs
will give off a paper-burning
smell. Open window to vent
smell. Operate fireplace on HI
position to burn off odor. This
will only last a few hours.
1. STOP! Read the safety information start-
ing in column 1.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting
the pilot, follow these instructions
exactly.
b. bEFORE LIGHTING smell all around
the appliance area for gas. be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
Figure 31 - Installing Screen
Screen
Screen
Rod
Rings
Screen Assembly
Front Center
Hole for
Right Screen
Assembly
Back Center Hole for
Left Screen Assembly
5. Insert each rod through ten rings located
at top of screen (see Figure 31).
6. Insert first rod into hole in left side of fire
-
box. Fasten rod to rear hole near center
of firebox using black Phillips head screw
(see Figure 31).
7. Insert other rod into hole on right side of
firebox and fasten rod to front hole near
center of firebox using remaining sheet
metal screw.
