113
Output
Single Amp
Bi-‐Amp
Tri-‐Amp
Subwoofer
L1
no connection
no connection
Woofer 1
Sub 1
L2
Speaker 1 (left)
Woofer 1
Mid-‐range 1
no connection
L3
no connection
Tweeter 1
Tweeter 1
no connection
R1
no connection
no connection
Woofer 2
Sub 2
R2
Speaker 2 (right)
Woofer 2
Mid-‐range 2
no connection
R3
no connection
Tweeter 2
Tweeter 2
no connection
The PDC Configuration also includes reserved memory space on the PDC Hardware that can be
used for storing correction filters. For each Speaker Configuration connected to the PDC
Configuration, there can be speaker correction filters to filter the audio signal from input to output.
The supported PDC Configurations are listed in the table below. In this table the ‘L’ and ‘R’ are
assumed to be the left and Right channels respectively. When using multiple PDC units this may
not be the case and the actual loudspeaker connected to a channel will depend on the installation.
PDC Configuration
Allocated Output
L Channels
R Channels
Single Amp with Stereo Subs
L2 – Left Speaker
R2 – Right Speaker
L1 – Left Subwoofer
L1 – Left Subwoofer
Single Amp with Mono Sub
L2 – Left Speaker
R2 – Right Speaker
L1 – Mono Subwoofer
R1 – Same as L1
Bi Amp with Stereo Subs
L3 – Left Tweeter
R3 – Right Tweeter
L2 – Left Woofer
R2 – Right Woofer
L1 – Left Subwoofer
R1 – Right Subwoofer
Summary of Contents for DEQX-Cal
