48
you wish to configure Profile 3 to have that correction set.
Method,
1. Double-click on the box for the left speaker – this brings up the Left: Filter Properties box.
2. On the Main Filter tab, select Use a correction filter for this loudspeaker.
3. Select Calibration Templates, then the speaker name, the Correction Set you generated, then
the speaker that you have set up in the left position. (Refer to the figure below)
4. Click OK.
5. Double-click on the box for the right speaker and repeat steps 1 to 4 above for that speaker.
Summary of Contents for DEQX-Cal
