1. Verify that water supply valve is open.
2. turn main power switch “ON” (located in the
back of the rear access cover).
Note: When the processor is first turned on,
the low temperature light flashes until
processing temperature is reached, then
goes off.
3. Set proper Development time:
1
—Emergency films (Endo, wet).
4 1/2
—Normal Operation.
6
—If “Low Temp” light flashes.
4. On
810 BASIC
, depress “RUN” button to
process film. Verify “PROCESS” light is on.
5. On
9000
, insert film in film input slot. Unit
starts automatically.
6. On
810 BASIC
, Release “RUN” button to turn
off processing cycle after last film exits. The
“PROCESS” light will go off and the processor
will go into standby.
Note: On the model
9000
, the processor
automatically goes into standby
after the last film is developer.
7. Turn main power switch “OFF” at end of the
day. Remove front access cover. Close water
supply valve.
DENT-X Processor Operation
LABELS, (Cont’d)
12
