Denso QB30-SR, User Manual

Page: 85 / 139

Chapter 16 Parameters and Defaults
The tables below list the parameters and their defaults. Those parameters can be changed with the QR-coded parameter menu
or configuration software (QB Setting), except shadowed ones only with the configuration software.
When the scanner leaves the factory, all of these parameters are set to defaults.
(1) Reading mode related parameters
Items Parameters Defaults Refer to:
Regular read mode

Scan entry mode
Data verification mode
File entry mode
Chapter 8
Section 8.1
Non-edit mode

Data extraction mode
Data conversion mode
Blocksorting mode
Data edit mode
ADF script mode
Chapter 8
Section 8.2
Enabled
Bar code reader mode
Disabled

Chapter 8
Section 8.6
Double scan enabled
Double scan prevention time
Double scan prevention time
Setting range 0.1- 9.9 seconds
0.5 seconds
Chapter 5
Disabled

Decode limitation time
0.05s – 9.99 s
Chapter 8
Section 8.5
Automatic

Fixed shutter, Variable gain
Luminosity setting
Fixed shutter, Fixed gain
Shutter time 0.1-9.9ms 0.5ms
Gain level 0-15 8
Chapter 10
TrOn

External illumination
synchronized signal
TrOff
Chapter 11
Section 11.6
Synchronous
Data Output Timing
Asynchronous

Chapter 11
Section 11.4
Disabled

Unread cord transmission
Enabled
Chapter 7
Unread cord
Designate up to 7 characters with
ASCII characters
“ERROR”
(Note 1)
Chapter 7
Scanning start command
Designate up to 7 characters with
ASCII characters
“READON”
(Note1)
Chapter 7
Scanning end command
Designate up to 7 characters with
ASCII characters
“READOFF”
(Note1)
Chapter 7
: Can be changed only with the configuration software.
(Note 1) 0x20
～
0x7E can be registered excluding the control characters of ASCII character codes.
74