29
Getting started
Connections
Basic operations
Advanced Operations
Advanced operations
Troubleshooting
Explanation terms
Information
Specifications
Index
EnGlisH
Setting the network [Network]
•
For details on “Network First Setup” (
v
page 10).
•
If you cancelled “Network First Setup” menu or changed the
network environment, perform “Menu” – “Network” – “Network
First Setup”.
Connecting wired LAN
Use this procedure to configure the wired LAN settings.
n
Network connecting
(when “DHCP”settings are “On”)
When using this unit with the broadband router’s DHCP function
enabled, this unit automatically performs the IP address setting
and other settings.
1
Connect the ETHERNET cable (
v
page 7
“Connecting to a network (LAN)”).
2
Press
ON/STANDBY
to turn on power to the main
unit.
3
Press
[MENU]
.
Turns on the Menu settings mode and the Menu appears on
the display (
v
page 28 “Menu map”).
4
Use
ui
to select “Network” – “Connection” –
“DHCP (On)”, then press
[ENTER]
,
<
1
/
3
ENTER>
or
p
.
“Select DHCP” menu appears.
5
Use
ui
to select “On”, then press
[ENTER]
,
<
1
/
3
ENTER>
or
p
.
“Setup Wired” menu appears.
6
Use
ui
to select “Connection”, then press
[ENTER]
,
<
1
/
3
ENTER>
or
p
.
“Connecting” is displayed, and the unit starts connecting to
the LAN.
•
When the connection is made successfully, “Succeeded” appears.
•
If the connection cannot be established, “Connection Failed” is
displayed. Perform steps 1 – 5 again.
You may need to set the network connection manually, depending
on the provider you use. To set the connection manually, use the
setting procedure of “Network connecting (when “DHCP” settings
are “Off”)”.
n
Network connecting
(when “DHCP” settings are “Off”)
This section explains the settings when connecting this unit to a
network that does not have a DHCP function.
To configure the settings manually, check the setting details with
your network administrator.
1
Perform steps 1
–
4 of the “Network connecting
(when “DHCP”settings are “On”)” procedure and
select “Off” in step 5.
“Select DHCP” menu appears.
2
Use
ui
to select “IP Address”, then press
[ENTER]
,
<
1
/
3
ENTER>
or
p
.
“Input IP Address” menu appears.
3
Use
uip
or
[NUMBER] (0 – 9)
to input the IP
address and press
[ENTER]
or
<
1
/
3
ENTER>
.
4
Use
uip
or
[NUMBER] (0 – 9)
to input the address
for “Subnet Mask”, “Gateway”, “Primary DNS”,
and “Secondary DNS”.
5
Use
ui
to select “Connection”, then press
[ENTER]
,
<
1
/
3
ENTER>
or
p
.
“Connecting” is displayed, and the unit starts connecting to
the LAN.
•
When the connection is made successfully, “Succeeded” appears.
•
If the connection cannot be established, “Connection Failed” is
displayed. Perform steps 1 – 4 again.
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control
[BUTTON]
Symbols used to indicate buttons in this manual
ui
p
<
1
/
3
ENTER>
ON/STANDBY
ui
p
[ENTER]
[MENU]
[NUMBER]
(0 – 9, +10)
