48
ENGLISH
For speaker impedance and speaker cable connections, see page 4.
Connect
Set up speakers
around items indicate the settings.
1
Set up the
remote control unit
n
Set up the zone mode
Press
ZONE SELECT
to switch the
zone mode to “MAIN”.
The “MAIN” indicator lights.
Press ZONE SELECT
n
Set up the operation mode
Press
AMP
to set the remote control
unit to amplifier operation mode.
Press AMP
2
Connect the setup microphone.
[1/6]
STEP1 Preparation
Connect the speakers
and place them accord-
ing to the recommenda-
tions in the manual.
Set the following
items if necessary.
Start Auto Setup
Amp Assign
Channel Select
Auto Setup Start
AUTO SETUP
AUDYSSEY AUTO SETUP
ENTER
Enter
RETURN
Cancel
MultEQ XT
When the setup microphone is
connected, the following screen is
displayed.
This section provides the setup methods of speaker systems other than the 7.1-channel system
(with surround back speakers).
For the setup methods of the 7.1-channel system with surround back speakers, see “Simple
version”, “Set up speakers (Audyssey® Auto Setup)” (
v
page 6) of “Simple version”.
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to
match your speaker environment (
v
page 49 “Set up “Amp Assign””).
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and
measuring time can be reduced (
v
page 49 “Set up “Channel Select””).
5.1-c 2.1-channel connection
If front speakers for 2-channel playback are connected to the SURR. BACK/AMP ASSIGN terminals, both
speakers for multichannel playback and for 2-channel playback can be used, by switching.
In this case, set “Set up “Amp Assign”” (
v
page 49) to “2CH”.
FL
FL
FR
FR
C
SW
SL
SR
Multi channel playback
(Surround mode)
2-channel playback
(Direct/Stereo mode)
Switching
• For switching multichannel playback and 2-channel playback, see “Selecting a listening mode (Surround
mode)” (
v
page 40).
• If “2ch Direct/Stereo” – “Setting” (
v
page 78) is set to “Custom”, settings for 2-channel playback
speakers can be made.
