Page 23
1
1.
00372
16 5/16”-18UNC x 1 1/2” Hex Head Bolt Gr. 5
2.
02592
8 3/8”-16UNC Nylon Locknut
3.
02802
44 5/16-18UNC Nylon Locknut
4.
03169
18 5/16”-18UNC x 1 1/4” Slotted Bolt
5.
00675
8 3/8”-16UNC x 5” Hex Head Bolt Gr. 5
6.
00004
58 5/16” Flat washer
7.
02990
8 5/16”-18 UNC x 1” Hex Head Bolt Gr. 5
-
12205-30
1 Fender Mount, Slope Side Front (long)
-
12206-30
1 Fender Mount, Slope Side Rear (long)
9.
12207-30
1 Fender Mount, Door Side Rear (short)
10.
12208-30
1 Fender Mount, Door Side Front (short)
11.
12209-30
2 Inner Fender Support, Front
12.
12210-30
2 Inner Fender Support, Rear
13.
12211-30
2 Cross Tube
14.
12212-30
2 Clamp Bar
15.
12213
2 Front Fender Half with offset
16.
12214
2 Front Fender Half without offset
17.
12215
2 Rear Fender Half with offset
18.
12216
2 Rear Fender Half without offset
Ref. PART
No.
No. qTy.
descRIPTIoN
fender Assembly on 550-750 Gravity flow Wagons
2
3
4
6
14
13
12
11
10
5
6
13
14
5
1
2
6
6
6
3
1
6
6
3
3 6
6
3
3
6
4
6
9
1
6
4
6
17
18
15
16
7
6
7
6
Mount Inner Fender Supports (11 & 12) to the inside
of the plastic fenders. On the Front, the overlap of the
plastic fender mounts to the cross strap of the inner fender
support. On the Rear, the overlap of the plastic fender
does not mount to the cross strap of the inner fender
support.
Mount the Fender Mounts (9 & 10) to the corner posts.
(Follow directions on following page)
Mount Cross tube (13) to bottom of sill tubes of wagon
using the clamp bar (14) and 4 3/8”X5” bolts (5). Clamp
bar mounts between the sill tubes. Do not tighten bolts
yet. Be sure cross tube is assembled in the right direction.
Refer to detail A above.
Attach Fenders with inner supports to mounting brackets
and cross tube. Adjust cross tube (13) front to back so
fender misses tire when turning. Tighten mounting bolts.
detail A
Summary of Contents for Gravity Flow 550
Page 1: ...Page 1 10 17 AG20021 Rev 1...
Page 25: ...Page 25 NOTES...
Page 26: ...Page 26 NOTES...
Page 27: ...Page 27 NOTES...