CAUTION
Risk of injury.
Oils and lubricants may pose a health hazard.
Contact with these media may result in serious damage to health (poisoning, allergies, skin irritations, etc.).
CAUTION
Risk of injury.
Leaking oils and lubricants are hazards due to the increased risk of slipping.
Spilt oils and lubricants must be absorbed immediately by means of sawdust or oil absorbent and disposed of in
an environmentally compatible way.
8.2
Basic maintenance requirements
General information on maintenance/repairs
The specified inspection and maintenance intervals (
"Maintenance schedule", Page 39) apply to normal
DRF 200 friction wheel travel drive operating conditions. Under normal operating conditions, friction wheel travel
drives are almost maintenance-free.
All wearing parts must be checked in the course of the annual inspection.
For single-shift operation and medium duty, a general overhaul should be carried out by an experienced techni‐
cian authorised by the manufacturer after 8–10 years of use.
If routine maintenance reveals that the intervals are too long, they should be adapted to the specific operating
conditions.
Pay attention to the following when working on machinery or machine equipment:
1.
Wear personal protection equipment.
2.
Before starting any maintenance work, switch off the mains connection switch and protect it against unau‐
thorised or accidental re-connection to the power supply by locking it with a padlock.
3.
Only carry out maintenance work on the DRF 200 friction wheel travel drive when the load has been re‐
moved.
4.
Ensure that there is sufficient freedom of movement. Keep the working area clean and tidy. Loose parts or
tools left lying around may cause accidents.
5.
Stop all moving parts and ensure that they cannot start moving while maintenance work is being carried out.
6.
Observe the relevant accident prevention regulations, instructions concerning appropriate use and statutory
regulations for operation and maintenance.
7.
Observe the relevant safety regulations when repairing electric equipment.
8.
Reinstall safety devices as required by relevant regulations and check them for correct operation after finish‐
ing maintenance work.
Maintenance work which is not possible from the ground may only be carried out from work stands or platforms.
The danger zone below the DRF 200 friction wheel travel drive must be fenced off if there is a risk of falling ob‐
jects.
Instructions for maintenance work in the course of operation
If maintenance work has to be carried out on the DRF 200 friction wheel travel drive in the course of operation,
special safety precautions must be taken depending on the operating situation. In each individual case, the owner
or the person assigned by him must check whether the maintenance work may be carried out in the course of
operation without risk of personal injury and, taking into account the local conditions, must implement all necessa‐
ry safety precautions.
Replace damaged or deformed spring clip fasteners and split sleeves.
Defective bolted connections must be replaced.
Ensure that operating and auxiliary materials and replaced parts are disposed of in an environmentally friendly
manner.
38
214
39
5 44/120
914
Summary of Contents for DRF 200
Page 51: ...214 395 44 120914 51...