DeLuxe Stitcher IMSHP-A25, Operation And Maintenance Manual

Page: 7 / 56

Carefully inspect the condition of the shipping container before unpacking your MiniStitcher. If the
container is broken or damaged and there is evidence that the machine may be damaged,
immediately notify the carrier who delivered the stitcher and the DeLuxe Stitcher Graphic Arts
Representative from whom the machine was purchased.
Installation
5
Pre-Inspection
As you carefully unpack the machine, check to make sure all components were delivered and are
in good working order. Use Figure 2 in this manual for reference to the following pieces:
• MiniStitcher
• Foot Switch with a Guard and Cord (PG10230)
• Wire Spool (25G5 or 2125G5 - optional) on a Spool Shaft (MG10110)
• Spool Cradle (MG10113)
• Wire Guide Spring (MG10009A)
• Table Base (MG10180)
• Driver Release Pin (5160)
• 1/8” Hex Key Wrench (PG10293)
• Stitch samples
Note: Check the nameplate on the back
of the stitcher to verify the operating
voltage meets your requirements.
Inspection
Place the MiniStitcher in a location where the
operator will have sufficient light and working
space. Ensure the machine is set up on a sturdy
table, heavy enough to support its weight.
For added stability, remove the Table Base
(MG10180) and screw the MiniStitcher to a sta-
ble worktable or to a MiniStitcher Floor Stand
(an optional purchase). Unsuitable Stands will
have a tendency to tip onto the operator.
Set Up (Figure 1)
Figure 1 - Set Up
MG10180