MVBX2-X User’s Manual
20
z
Follow the steps mentioned below to install the FDD device :
z
Locate the FDC1 box header on the motherboard.
z
FDC1-Connect one end of the 34-Pin ribbon cable that come with the drive to the
FDD header, and the other end of the cable to the FDC1 box header on the
motherboard. (Note: Each header has the Pin-1 side clearly marked. The Pin-1
side of the each ribbon cable is always marked with a red stripe on the cable.)
Step4: Front Panel I/O Connections
This motherboard connects to the front panel I/O are located on jumper block J2.
Follow the instruction carefully for proper connections to your front panel display
and control. This section explains how to connect these components.
z
z
z
z
z
PW-SW :
It is a 2-Pin header connects to the chassis-mounted power button.
z
z
z
z
z
RST-SW :
It is a 2-Pin header connects to the chassis-mounted reset switch and is
used to reboot the system.
z
HD-LED :
It is a 2-Pin header connects to the chassis-mounted HDD LED to
indicate HDD activity.
z
SPEAKER :
It is a 4-Pin header connects to the chassis-mounted speaker. When
system has any abnormally state that you will hear warnings through speaker.
z
PW-LED :
It is a 3-Pin header connects to the chassis-mounted power LED to
indicate onboard power state.
z
KB-LK :
It is a 2-Pin header connects to the chassis-mounted key lock switch that is
used to lock the keyboard for security purpose.
Master
Slave
Red Stripe
Pin-1
FDC1
Rear of Floppy
Disk Drive
