6. BIOS Configuration
MVBX2-X User’s Manual
43
The auto-detection feature can only detect one set of parameters for a particular IDE
hard drive. Some IDE drives can use more than one set. This is not a problem if the drive
is new and empty.
IMPORTANT:
If your hard disk was already formatted on an older previous system, incor-
rect parameters may be detected. You will need to enter the correct parameters manually
or use low-level format if you do not need the data stored on the hard disk.
If the parameters listed differ from the ones used when the disk was formatted, the disk will
not be readable. If the auto-detected parameters do not match the ones that should be
used for your disk, do not accept them. Press <N> to reject the presented settings and enter
the correct ones manually from the Standard CMOS Setup screen.
Save & Exit Setup
Select this option to save into the CMOS memory all modifications you specified during the
current session. To save the configuration changes, highlight the “
Save & Exit Setup
”
option on the main screen, type “Y”, and then press <Enter>.
Exit Without Saving
Select this option to exit the Setup utility without saving the modifications you specify
during the current session. To exit without saving, highlight the “
Exit without Saving
”
option on the main screen and then press <Enter>.
