12
HOW TO ATTACH THE ROLLER EXTENSION
TABLES TO THE STAND
1. Attach the stand support to the extension roller table.
To do this, remove hex head bolts and washers (CC)
Fig. 19 that secure bar (DD) to roller table.
2. Then, place bar (DD) into each end (EE) of stand sup-
port.
3. Re-attach bar (DD) Fig. 20 to extension roller table as
shown with hex head bolts and washers removed in
STEP 1.
4. Align the three holes (EE) Fig. 21 in the end of the ex-
tension table with the three holes in the planer base.
loosely secure the table with the three M6 hex head
bolts and M6 flat washers.
3. Position the stand support (FF) Fig. 22 on edge of
side panel above the clip (GG).
5. Follow procedure
Adjusting The Roller Extension
Tables
in next section.
7. Attach the back extension table in the same manner.
both the front and back roller extension tables can be
lowered when the machine is not in use. Raise the end
of the extension table slightly, move the stand support
inward, and lower the extension table (Fig. 24).
EE
FF
CC
DD
EE
DD
GG
Fig. 19
Fig. 20
Fig. 22
Fig. 21
Fig. 23
Fig. 24