10
HOW TO LIFT THE MACHINE
IMPORTANT:
Take care when you lift the machine. The
planer is very heavy. Use the following directions and a
MINIMUM OF FOUR PEOPLE
to place the machine on
the stand.
Turn the elevation handwheel (O) Fig. 15 clockwise to
raise the cuttinghead. Insert two 2 x 4's (as shown in
Fig. 15) between the cuttinghead and the table. lower the
cuttinghead to touch the 2 x 4's. Use four people, one on
each end of the 2 x 4’s, to move the machine.
Fig. 15
ATTACHING TOP COVER AND DUST HOOD
1. Using a 10 mm wrench, fasten top cover (T) Fig. 11 to
planer head using three M6 hex head flange screws at
three spots (U).
NOTE:
The fourth hole is used later when securing cord
to the planer head.
NOTE:
Elevation handwheel shown removed to make
top cover assembly easier.
2. Loosen bolts (V) Fig. 12 with provided 17 mm wrench
and fit the dust collector's slots (W) down behind the
washers. be sure the top lip of the dust collector rests
on top of the top cover as shown in Fig. 13.
3. Attach top of dust collector to top cover with M5
Phillips head self-tapping screws and M5 washers, at
two spots (X) as shown in Fig. 13.
4. Tighten bolts (V) Fig. 12.
HOW TO SECURE THE POWER CORD
Fold and position the two cord clamps (Y) Fig. 14 on the
power cord (Z). Use the two M6 x 16 mm screws and two
M6 washers to secure the cord and fasten the left corner
of the top cover to the planer.
Fig. 11
U
V
T
Fig. 12
Fig. 13
X
W
Y
Z
Fig. 14
O