DELTA DORE TTGSM TYXAL+, Installation Manual

Page: 64 / 232

65 64
8.9 Association of home automation functions with repeater
If the transmitter does not find any re-
ceiver during an association operation;
(e.g. the gate receiver is out of wireless
range).
You can use another receiver of the
installation that will serve as a repeater
to reach the required receiver.
To do this:
• Place the receiver out of wireless range while waiting for the association.
• Choose a receiver of the installation within range of the transmitter,
and set it to association wait mode.
• Start the association.
Example for a gate receiver, type #430 then type 1
•
The transmitter displays: "configuring..."
After a few seconds, the transmitter announces the number of receivers found
on the installation:
Example: "1 gate associated, 1 repeater associated".
8. Association of home automation functions
8.8 To associate scenarios (4 scenarios can be created)
• Set the receivers to the required status (e.g. light off and roller shutter closed),
• Set the relevant receivers to association wait mode.
• From the main menu,
type #601 for scenario 1, then 1
type #602 for scenario 2, then 1
type #603 for scenario 3, then 1
type #604 for scenario 4, then 1
•
The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of receivers found on the installation:
Example: 3 roller shutters associated, 2 receivers associated.
Check that the association was successful:
• the motors briefly start twice
• the LED of the receivers has stopped flashing.
8.7 To associate X3D lighting receivers (unit 1)
• Set all the receivers to association wait mode (refer to the user guide).
• From the main menu, type
#420 then type 1
•
The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of receivers found on
the installation:
Example: "6 lighting points associated, 0 repeater associated".
Check that:
• the LED of the receivers has stopped flashing.
Repeat the same procedure to associate the lighting receivers of unit 2, by typing #421
8.6 To associate an X3D gate receiver (TYXIA 6410).
• Set the receiver to association wait mode (refer to the user guide).
• From the main menu, type
#430 then type 1
•
The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of receivers found on
the installation:
Example: "1 gate associated, 0 repeater associated".
Check that:
• the receiver LED has stopped flashing.