DELTA DORE TTGSM TYXAL+, Installation Manual

Page: 62 / 232

63 62
8. Association of home automation functions
The home automation functions remotely enable
you to:
- control the heating.
- control 5 sets of control systems
(2 channels for ROLLIA roller shutters or roller
shutter receivers, 2 lighting channels, 1 gate
channel).
- control 4 scenarios.
These functions can be performed if the equipment
allows (X3D receivers).
You can check it with our customer services.
Associations can be of 2 types:
• direct association
• repeater: if the receiver or receivers are used as
relays to extend the signal to other
receivers normally out of wireless range (extended
installations, thick concrete walls, etc.).
Dial # followed by the number corresponding
to the function chosen then type 1.
Example: thermal comfort function
dial #400 then type 1.
Dial # followed by the number corresponding to
the function chosen then type 0.
Example: thermal comfort function
dial #400 then type 0.
The association of all the products of this unit is
deleted.
• Dial the call number of the installation
• Enter your access code
From the main menu:
To associate a home automation function To delete a home automation function
8.2 Principle
X3D gate
receiver
X3D lighting
receivers
8.1 Compatible products
CALYBOX 2020 WT
Energy manager
Scénarios
Réglages
11.5°C Lun. 23 Septembre
18:28
Autres
Conso Thermique
Volets
Ouvrant
31
Calendrier
Eau chaude
ROLLIA X3D
Roller shutter motors
Roller shutter receivers
8.4 To associate X3D thermal receivers
• Set all the receivers to association wait mode (refer to the user guides).
• From the main menu, type
#400 then type 1
•
The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of receivers found on
the installation:
Example: "5 thermal points associated, 0 repeater associated".
Check that:
• the LED of the receivers has stopped flashing.
8.3 To associate CALYBOX 1020, CALYBOX 2020,
TYBOX 1010, TYBOX 2010, TYBOX 2020
• Set the product to association wait mode (refer to the user guide).
• From the main menu, type
#401 then type 1
•
The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the product found
on the installation:
Example: "1 thermal points associated".
8.5 To associate ROLLIA X3D roller shutter motors
or roller shutter receivers (unit 1).
• Set all motors and all receivers
to association wait mode. (see its guide)
• From the main menu, type
#410 then type 1
•
The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of roller shutters
found on the installation:
Example: "3 roller shutters associated, 2 repeater associated".
Check that:
• the association was successful: the motors briefly start twice
• the LED of the receivers has stopped flashing.
Repeat the same procedure to associate the roller shutters of unit 2, by typing #411