127
2. Remove the filter (if present) and rinse with running water.
3. Replace the filter (if provided), fill the tank with fresh
water and replace the tank.
4. (Models with water softener filter only) Deliver about 100
ml of water.
12.7 Cleaning the coffee spouts
35
1. Clean the coffee spouts (A7)
regularly with a sponge or
cloth (fig. 35).
2. Check that the holes in
the coffee spouts are not
blocked.
If necessary, remove coffee de-
posits with a toothpick (fig. 35).
12.8 Cleaning the pre-ground coffee funnel
Check regularly (about once a month ) that the pre-ground
coffee funnel (A4) is not blocked. If necessary, remove coffee
deposits with the brush (C5) supplied.
12.9 Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see section
“7. Turning off).
2. Remove the water tank (A16- fig. 3).
3. Open the infuser door (A14- fig. 36) on the right side of the
appliance.
36
37
PUSH
PU
SH
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 37);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 38), then push the PUSH symbol fully
in until it clicks into place.
38
Please note!
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 39.
39
8. Once inserted, make sure the two coloured buttons have
snapped out (fig. 40).
40
PUSH
9. Close the infuser door.
10. Put the water tank back.
12.10 Cleaning the milk container
To keep the frother efficient, clean the milk container (D) every
two days as described below:
1. Remove the lid (D2).
2. Remove the milk spout (D5) and intake tube (D4).
3. Turn the froth regulator (D1) to the “INSERT” position (fig.
41) and pull it off upwards.
41
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dishwasher
safe, placing them in the top basket of the dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 42). If necessary, scrape the
groove with a toothpick.
42
43
5. Rinse inside the froth adjustment dial seat with running
water (fig. 43).
6. Check that the intake tube and spout are not clogged with
milk residues.
7. Replace the dial (in correspondence to the word “INSERT”),
spout and milk intake tube.
8. Place the lid back on the milk container.
12.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A8)
with a sponge to remove milk residues from the gaskets (fig.
27).
13. DESCALING
Descale the machine when the message “DESCALE” flashes on
the display (B13).
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
