28
DISPLAYED MESSAGE
POSSIBLE CAUSE
REMEDY
DESCALING NEEDED
PRESS OK TO START
(~45MIN)
ESC OK
The machine must be descaled.
Press " OK" to start descaling or "
ESC"
to descale later. The descaling procedure de-
scribed in section “16. Descaling” needs to be
performed.
REPLACE WATER FILTER
PRESS OK TO START
ESC OK
The water softener filter (C4) is exhausted.
Press OK to replace or remove the filter, or ESC
to carry out the procedure later. Follow the in-
structions in section “18. Water softener filter”.
GENERAL ALARM. REFER TO
USER MANUAL / APP
The inside of the appliance is very dirty.
Clean the inside of the appliance thoroughly,
as described in section “15. Cleaning”. If the
message is still displayed after cleaning, con-
tact a customer service centre.
The appliance needs descaling and/or the filter
(C4) must be replaced.
The descaling procedure described in section
“16. Descaling” needs to be performed and/
or the filter needs replacing or removing as
described in section “18. Water softener filter”.
The tubes inside the milk container (D) must
be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(fig. 20).
The filter (C4) must be replaced.
Replace the filter or remove it as described in
section “18. Water softener filter”.
The machine must be descaled.
The descaling procedure described in section
“16. Descaling” needs to be performed.
The appliance may request descaling cycles at
very short intervals. This is normal and due to
the appliance’s advanced control system.
The auto-start function is enabled.
To disable the function, proceed as described in
section “8.6 Auto-start
”.
Energy saving is enabled.
To disable energy saving, proceed as described
in section “8.9 Energy saving ”.
The appliance is connected to a device via
bluetooth.
CLEANING UNDERWAY
PLEASE WAIT
The appliance has detected impurities in its
internal circuits.
Wait for the appliance to be ready for use again
and reselect the required beverage. Contact
Customer Services if the problem persists.