23
18.1 Installing the filter
41
1. Remove the filter (C4)
from the packaging;
2.
Press the selection
arrow (B2) correspond-
ing to the "
" symbol
(B8) to enter the menu;
3.
Press the selection
arrow corresponding to "
WATER HARDNESS";
4. "TURN DATE INDICATOR
TO NEXT 2 MONTHS" (fig.
41):
turn the date indicator
disk until the next two months of use are displayed. Press
the selection arrow corresponding to " NEXT>";
Please note
The filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last a maximum of three weeks.
42
5. "RUN WATER INTO FILTER
HOLE UNTIL IT COMES
OUT" (fig. 42): To activate
the filter, run tap water
through the hole in the
filter as shown in the
figure until water comes
out of the openings at the
side for more than a min-
ute. Press the selection
arrow corresponding to "
NEXT>";
6. Extract the tank (A16) from the appliance and fill with
water.
43
7. "IMMERSE FILTER TO
EXPEL AIR BUBBLES" (fig.
43): Insert the filter in the
water tank and immerse
it completely for about
ten seconds, sloping it
and pressing it lightly to
enable the air bubbles to
escape. Press the selec-
tion arrow corresponding
to " NEXT>";
8. "INSERT FILTER IN
HOUSING": Insert the filter in
the filter housing (A17-fig. 40) and press as far as it will go.
Press the selection arrow corresponding to "NEXT>";
9. "INSERT WATER TANK": Close the tank with the lid (A15),
then put the tank back in the machine (fig. 6);
10. "POSITION 0.5L CONTAINER, PRESS OK TO ENABLE FIL-
TER" (fig. 8): Place the container under the hot water
spout (C6) and press " OK
". Delivery begins and stops
automatically.
The filter is now active and you can use the coffee machine.
18.2 Replacing the filter
Replace the filter (C4) when "
REPLACE WATER FILTER,
PRESS OK TO START" appears on the display (B1): To replace the
filter immediately, press the selection arrow corresponding to "
OK" and follow the instructions from point 4.
To replace the filter later, press the selection arrow correspond-
ing to "
ESC". The
symbol appears on the display to
remind you that the filter needs replacing. To replace, proceed
as follows:
1. Extract the tank (A16) and exhausted filter;
2. Remove the new filter from the packaging;
3. Press the selection arrow (B2) corresponding to the "
"
symbol (B8) to enter the menu;
4. Press the selection arrow corresponding to " REPLACE
WATER FILTER;";
5. Follow the operations described in the previous section
from point 4.
The filter is now active and you can use the coffee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
18.3 Removing the filter
If you want to use the appliance without the filter (C4), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A16) and exhausted filter;
2. Press the selection arrow (B2) corresponding to the "
"
symbol (B8) to enter the menu;
3. Press the selection arrow corresponding to " REMOVE
WATER FILTER";
4.
“
CONFIRM FILTER REMOVAL": to confirm press the
selection arrow corresponding to " OK" (to go back to
the settings menu, press the selection arrow correspond-
ing to "
ESC");
5. "
FILTER REMOVED": the change has been saved.
Press " OK" to go back to the homepage.
