27
DISPLAYED MESSAGE
POSSIBLE CAUSE
REMEDY
GROUND TOO FINE. ADJUST
MILL
ESC
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 11) one click clock-
wise towards 7 while the coffee mill is in
operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section “9.5 Adjusting the coffee mill”). If the
problem persists, make sure the water tank
(A16) is fully inserted.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water/steam spout (C6) in the
appliance and deliver a little water until the
flow becomes regular.
SELECT A MILDER TASTE OR
REDUCE COFFEE AMOUNT
ESC
Too much coffee has been used.
Select a milder taste by pressing "AROMA" (B5)
or reduce the quantity of ground coffee (maxi-
mum 1 measure).
INSERT WATER SPOUT
The hot water spout (C6) is not inserted or is
inserted incorrectly
Insert the water spout as far as it will go.
INSERT MILK CONTAINER
The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig.
18).
INSERT INFUSER ASSEMBLY
PUSH
The infuser (A19) has not been replaced after
cleaning.
Insert the infuser as described in section “15.9
Cleaning the infuser”.
DISPLAYED MESSAGE
POSSIBLE CAUSE
REMEDY
WATER CIRCUIT EMPTY
PRESS OK TO START
OK
The water circuit is empty
Press " OK" to deliver water from the spout
(C6) until it flows out normally.
If the problem persists, make sure the water
tank (A16) is fully inserted.
PRESS OK TO CLEAN OR TURN
DIAL
OK
The milk container has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
To proceed with the CLEAN function press "
OK", or turn the froth adjustment dial to one of
the milk positions.
TURN MILK FROTH
ADJUSTMENT DIAL
TO CLEAN POSITION
CLEAN
ESC
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(fig. 20).
TURN FROTH ADJUSTMENT
DIAL
The milk container has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
Turn the dial to the required froth position.
