3.7.2.3 Remove a Virtual Serial Port
1.
Select the virtual serial port in list which will be removed.
2.
Click the [Remove] button to remove the selected virtual serial port.
3.7.2.4 Configure a Virtual Serial Port
1.
Select the virtual serial port in list.
2.
Click the [Setting] button to configure the virtual serial port.
The virtual serial port supports following parameters that you can configure:
Parameter
Description
Connection Protocol
TCP or UDP connection type
Remote Host IP
The target device server’s IP address
Remote Host Port
The target device server’s port number
Enable Flow Control
Packet
Enable / disable the virtual serial port sending
and receiving flow control packets. This function
is dependent with the flow control function of
RS-232 to Ethernet Converter
firmware. If this
function is enabled on both virtual serial port and
firmware, both sides will add a 3-byte header
ahead of each egress Ethernet packet and will
strip off the 3-byte header of each ingress
Ethernet packet.
Connect at Windows Start Enable / disable the automatic connection
function at Windows start. When this function is
enabled, the virtual serial port will automatically
connect to the
target device server at Windows operating
system start.
