Figure 63. Removing the VGA Module
1.
screw
2. VGA module cable
3. VGA module
4. control panel
Related Links
Safety instructions
Before working inside your system
Installing the VGA module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: This procedure applies only to the eight hard drive system.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Keep the Philips #2 screwdriver ready.
Steps
1.
Push the VGA module into the chassis and align the threaded screw hole on the VGA module with
the screw hole on the chassis.
2.
Replace the screw (at the bottom of the chassis) that secures the VGA module to the chassis.
3.
Replace the control panel.
4.
Connect the VGA module cable to the VGA module.
131
