Dell PowerVault LTO5-140, User Manual

Page: 21 / 93

8. Connecting Host System Power and Testing Power to the Tape Drive
Connect the power cord to the system and to the electrical outlet. To ensure
that the drive is receiving power, watch for the following indicators while
turning on the power to the system:
a. The single-character display presents a series of random characters.
b.
The single-character display becomes blank (not lit).
c. The Fault LED briefly turns on, then the ready/activity LED turns on solid.
Installing External and Rack Mount Drives
Installing the Drive — Prerequisites
The SAS tape drive has a burst transfer rate of 600 MB per second. It is
recommended that a dedicated host bus adapter is used for the tape drive.
Your system must have a properly installed and configured SAS host adapter or a
SAS controller on the motherboard (if available) with driver software that supports
the tape drive. Do not connect to a RAID controller channel; RAID controller
channels are for disk drives only.
Installing the External Drive - Step-By-Step Instructions
Procedure
1. Positioning the Tape Drive
Position the tape drive convenient to the system. The only restrictions are the
length of the power cord and the length of the SAS cable. The following
locations are recommended:
v Away from high-traffic areas, especially if the floor is carpeted.
v
Out of copy rooms to avoid toner and paper dust. Do not store paper
supplies next to any unit.
v Away from moving air, such as doorways, open windows, fans, and air
conditioners.
a80hd007
Figure 2-5. Secure the Drive
Chapter 2. Setting Up the Tape Drive
2-5