Dell PowerEdge systems 6300, User Manual

Page: 89 / 143

I/O Ports and Connectors B-1
$ 3 3 ( 1 ' , ; %
,23RUWVDQG&RQQHFWRUV
This appendix provides specific information about the input/output (I/O) ports and con-
nectors on the back panel of the computer system.
,23RUWVDQG&RQQHFWRUV
The I/O ports and connectors on the back panel of the system are the gateways
through which the computer system communicates with external devices, such as a
keyboard, mouse, printer, and monitor. Figure B-1 identifies the I/O ports and connec-
tors for your system.
6HULDODQG3DUDOOHO3RUWV
The two built-in serial ports use 9-pin D-subminiature connectors on the back panel.
These ports support devices such as external modems, printers, plotters, and mice
that require serial data transmission (the transmission of data one bit at a time over
one line).
Most software uses the term COM (for communications) plus a number to designate a
serial port (for example, COM1 or COM2). The default designations of your system ’s
built-in serial ports are COM1 and COM2. COM1 is the bottom connector; COM2 is on
the top.
The built-in parallel port uses a 25-pin D-subminiature connector on the system’s back
panel. This I/O port sends data in parallel format (where eight data bits, or one byte,
are sent simultaneously over eight separate lines in a single cable). The parallel port is
used primarily for printers.
Most software uses the term
LPT (for line printer) plus a number to designate a parallel
port (for example, LPT1). The default designation of the system’s built-in parallel port
is LPT1.
Port designations are used, for example, in software installation procedures that
include a step in which you identify the port to which a printer is attached, thus telling
the software where to send its output. (An incorrect designation prevents the printer
from printing or causes scrambled print.)