Installing System Components
53
If a replacement hard drive does not have the hard-drive bracket attached, remove the bracket from the
old drive.
6
Snap the new drive into the guide bracket. See Figure 3-10.
7
Insert the guide bracket assembly into the drive bay until it snaps into place. See Figure 3-9.
Figure 3-10.
Installing a Hard Drive in a Drive Bracket
NOTICE:
SAS drives and SATA drives cannot be mixed in the system. The drives must be either SATA or SAS hard
drives.
NOTE:
The SAS controller card must be installed in PCIe SLOT2. See Figure 6-2.
8
Connect the power cable to the hard drive.
9
Connect the data cable to the hard drive:
•
For connection to the integrated SATA controller (SATA hard drives only), connect the SATA data
cable to the SATA0 (first drive) and SATA2 (second drive) connectors on the system board. See
Figure 3-11. See Figure 6-2 for the location of the hard drive connectors on the system board.
•
For connection to a SAS controller expansion card (SAS or SATA hard drives), connect the data
cable from the SAS controller card and the power cable as shown in Figure 3-12.
See "SAS
Controller Expansion Card
" on page 58
for instructions about installing the card and routing
the cables.
1
hard drive
2
hard drive bracket
1
2
book.book Page 53 Tuesday, August 25, 2009 1:14 PM
Summary of Contents for POWEREDGE SC440
