Replacing the NVRAM backup battery - Option B
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the
safety instructions that came with your system for additional information.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the following:
a
Drives
b
Drive backplane
Steps
1
Locate the system battery on the system.
2
To remove the battery:
a Push the battery holder slightly away.
NOTE:
Ensure that you do not push the battery holder more that 3.2 millimeters or you might risk damaging
the part.
b Push the battery toward the positive side of the battery till the battery disengages from the connector.
c Lift the battery away from the system.
Figure 43. Removing the system battery
3
To install a new system battery:
a Push the battery holder slightly away.
NOTE:
Ensure that you do not push the battery holder more that 3.2 millimeters or you might risk damaging
the part.
b Hold the battery with the "+" sign facing the positive side of the battery connector.
c Insert the battery down into the connector and push the positive side of the battery until the battery snaps into place.
Installing and removing system components
87