Dell PowerEdge C6320p, Owner'S Manual

Page: 175 / 194

Figure 123. Installing thesensor board cover
Related links
Safety instructions
Removing the sensor board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives from the system before
removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before removal so that you can
replace them in the same locations.
NOTE: Observe the routing of the cable on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove all the hard drives.
4. Disconnect all the cables from the backplane.
5. Disconnect control panel cables from the power distribution board.
6. Remove the hard drive cage from the chassis.
7. Keep the Phillips #2 screwdriver ready.
Steps
1.
Remove the screw that secures the sensor board assembly to the hard drive cage.
2. Disconnect the cable from the sensor board assembly.
3. Remove the sensor board assembly from the hard drive cage.
175