Destination file name: 0126.bix
/
Console#
Configuration
From the
Configuration
page you can save and restore switch configuration settings.
The
Configuration
page contains the following editable fields:
l
Transfer Configuration to Server
—
Copies a switch configuration file to a TFTP server.
l
Transfer Configuration from Server
—
Copies a switch configuration file from a TFTP server.
l
Remove Configuration File
—
Deletes a configuration file from the switch (selected from the drop-down menu).
l
Start-Up Configuration File
—
Selects the configuration file to be used after a system start-up (selected from the drop-down menu).
l
Copy Running Config to File
—
Saves the current session configuration settings. Specifies a new filename or the name of an existing file to be replaced.
Transferring a Configuration File to a Server
1.
In the
Transfer Configuration File to Server
field, enter the IP address of the TFTP server in the
TFTP Server IP Address
field.
2.
In the
Source File Name
field, select the configuration file to upload from the drop-down menu.
3.
For the
Destination File Name
, type a filename to identify the configuration file on the TFTP server.
4.
Click
Transfer to Server
.
Transferring a Configuration File from a Server
1.
Under
Transfer Configuration File from Server
, enter the IP address of the TFTP server in the
TFTP Server IP Address
field.
2.
In the
Source File Name
field, type the filename of the configuration file to download.
3.
In the
Destination File Name
field, select a configuration file to replace from the drop-down menu, or specify a new filename (with no more than 32
characters). Filenames are case-sensitive and cannot contain spaces. The switch can contain any number of configuration files, limited only by available
flash memory space. You can use the
dir
command in the CLI to check the available flash memory space.
4.
Click
Transfer from Server
.
Deleting a Configuration File from the Switch
1.
In the
Remove Configuration File
field, select the file to delete from the drop-down menu.
2.
Click
Remove File
.
Selecting the Start-up Configuration File
1.
In the
Start-Up Configuration File
field, select the start-up configuration file from the drop-down menu.
2.
Click
Apply Changes
.
NOTE:
The switch is shipped with one default configuration file (
Factory_Default_
Config.cfg
) installed, which is set as the start- up file. This file cannot be removed from the system.
NOTICE:
For configuration changes to persist beyond the current session, you must save the
running-config
file from this page, or use the CLI
command
copy running-config startup-config
.
NOTE:
The CLI also allows you to copy files within the switch and replace a running configuration file without performing a reset.
