Dell P110F, Service Manual

Page: 40 / 111

6. Connect the WLAN-antenna cables to the respective connectors on the WLAN-antenna module.
7. Place the WLAN-antenna module bracket on the system board.
8. Align the screw holes on the WLAN-antenna module bracket with the screw holes on the system board.
9. Replace the screw (M2x2) to secure the WLAN-antenna module bracket to the system board.
10. Connect the touch-screen cable (for computers shipped with a touch screen), display cable, IR-camera cable (for computers
shipped with an IR camera), and sensor daughter-board cable (for computers shipped with a sensor board) to the system
board.
11. Place the display-cable bracket on the system board.
12. Align the screw holes on the display-cable bracket with the screw holes on the system board.
13. Replace the two screws (M2x2) to secure the display-cable bracket to the system board.
Next steps
1. Install the thermal module .
2. Install the base cover .
3. Follow the procedure in After working inside your computer .
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the base cover .
3. Remove the 3-cell battery or the 4-cell battery , whichever applicable.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Steps
1. Disconnect the coin-cell battery cable from the connector on the system board.
40 Removing and installing components