Dell N2000 Series, Configuration Manual

Page: 163 / 1460

Setting Basic Network Information
163
Configuring Static Network Information on the OOB Port
NOTE:
N2000 switches do not have an out-of-band interface.
Beginning in Privileged EXEC mode, use the following commands to
configure a static IP address, subnet mask, and default gateway on the OOB
port. If no default gateway is configured, then the zero subnet (0.0.0.0) is
used. In this configuration, the OOB port can reach hosts in the local subnet
only, because the OOB port will not be able to issue ARP requests to the
default gateway. Configuring a default gateway address on the OOB port
allows the OOB port to issue ARPs and address traffic to hosts on other
subnets. The OOB port subnet may not overlap with any in-band VLAN
subnet.
NOTE:
The out-of-band port also supports IPv6 address assignment, including IPv6
auto-configuration and an IPv6 DHCP client.
Configuring Static Network Information on the Default VLAN
Beginning in Privileged EXEC mode, use the following commands to
configure a static IP address, subnet mask, and default gateway on the default
VLAN. Alternatively, a DHCP server may be used to obtain a network address.
The switch also supports IPv6 address auto-configuration.
Command Purpose
configure Enter Global Configuration mode.
interface out-of-band Enter Interface Configuration mode for the OOB
port.
ip address
ip_address
subnet_mask
[
gateway_ip
]
Configure a static IP address and subnet mask.
Optionally, you can also configure a default gateway.
ipv6 address
prefix/prefix-
length
Configure an IPv6 prefix for the OOB port
ipv6 address enable
Enable IPv6 addressing on the OOB port
ipv6 address autoconfig Enable IPv6 auto-configuration for the OOB port
ipv6 address dhcp Enable DHCP address assignment for the OOB port.
CTRL + Z Exit to Privileged EXEC mode.
show ip interface out-of-band Verify the network information for the OOB port.