Dell N2000 Series, Configuration Manual

Page: 1182 / 1460

1182
Configuring OSPF and OSPFv3
console(config-if-vlan12)# exit
7 Define the OSPF and OSPFv3 router IDs for the switch:
console(config)# ipv6 router ospf
console(config-rtr)#
router-id 3.3.3.3
console(config-rtr)# exit
console(config)# router ospf
console(config-router)# router-id 3.3.3.3
console(config-router)# exit
Switch B is a ABR that connects Area 0 to Areas 1 and 2.
To configure Switch B:
1 Configure IPv6 and IPv4 routing. The static routes are included for
illustration only: Redistributed static routes, like routes distributed from
other protocols, are not injected into stub areas such as Area 1:
console# configure
console(config)# ipv6 unicast-routing
console(config)# ipv6 route 3000:44:44::/64
3000:2:3::210:18ff:fe82:c14
console(config)# ip route 10.23.67.0 255.255.255.0
10.2.3.3
2 Create VLANs 5, 10, and 17.
console(config)# vlan 5,10,17
console(config-vlan5,10,17)# interface gi1/0/1
console(config-if-Gi1/0/1)# switchport access vlan
5
console(config-if-Gi1/0/1)# interface gi1/0/2
console(config-if-Gi1/0/2)# switchport access vlan
10
console(config-if-Gi1/0/1)# interface gi1/0/3
console(config-if-Gi1/0/2)# switchport access vlan
17
3 On VLANs 5, 10, and 17, configure IPv4 and IPv6 addresses and enable
OSPFv3. For IPv6, associate VLAN 5 with Area 0, VLAN 10 with Area 1,
and VLAN 17 with Area 2.