Dell Inspiron 23, Service Manual

Page: 82 / 106

Replacing the Stand Assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Place the stand assembly on the display assembly.
2 Connect the touchscreen cable to the display panel and adhere the Mylar
over the touchscreen cable.
3 Slide the tabs on the stand assembly into the slots on the display bracket.
4 Align the screw holes on the stand assembly with the screw holes on the
display bracket.
5 Replace the screws that secure the stand assembly to the display bracket.
6 Route all the cables through their routing guides.
For more information, see
display panel with stand assembly .
7 Replace the screws that secure the cables to the display bracket.
8 Connect the power-button cable to the control-buttons board cable.
9 Connect the control-buttons board cable to the control-buttons board.
10 Slide the display cable into the display-cable connector slot and connect
the display cable to the display assembly.
11 Align the antenna modules with the alignment posts and adhere them to
the display bezel.
12 Connect the converter-board cable and the display-backlight cable to
the converter board.
Post-requisites
1 Replace the microphones .
2 Replace the camera .
3 Replace the back cover .
4 Replace the computer base .
82