Figure 60. Installing the optical or tape drive blank
Next steps
2. Follow the procedure listed in
After working inside your system
on page 67.
Removing the optical drive cage or tape drive
Prerequisites
NOTE:
The procedure to remove the optical drive cage is identical to removing a tape drive.
1. Follow the safety guidelines listed in
on page 66.
2. Follow the procedure listed in
Before working inside your system
3. If installed,
.
Steps
1. Disconnect the power and data cable from the back of the drive.
NOTE:
Observe the routing of the power and data cable inside the chassis as you remove them from the system board
and the drive. You must route these cables properly when you replace them to prevent them from being pinched or
crimped.
2. To remove the drive, push the release latch to release the drive.
3. Slide the drive out of the drive bay.
4. If you are not immediately replacing the tape drive, install the blank.
NOTE:
Blanks must be installed on empty optical drive or tape drive slots to maintain FCC certification of the system.
The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. Perform
the same steps to install blanks.
Installing and removing system components
103
Summary of Contents for 5WC10
Page 21: ...Figure 16 Configuration and layout Dell EMC PowerEdge T640 overview 21 ...
Page 22: ...Figure 17 Electrical overview 22 Dell EMC PowerEdge T640 overview ...
Page 23: ...Figure 18 Memory information Dell EMC PowerEdge T640 overview 23 ...
Page 24: ...Figure 19 System tasks 24 Dell EMC PowerEdge T640 overview ...
