Note
This appliance is also designed to connect to the IT power systems with a phase to
phase voltage not exceeding 240 V.
Note
If an appliance with 2000 W AC PSU operates at low line 100–120 V AC, then the
power rating per PSU is derated to 1000 W.
Note
If an appliance with 1600 W AC PSU operates at low line 100–120 V AC, then the
power rating per PSU is derated to 800 W.
Note
If an appliance with 1100 W AC PSU operates at low line 100–120 V AC, then the
power rating per PSU is derated to 1050 W.
Battery specifications
The VxRail P Series, V Series, and S Series appliances supports CR 2032 3.0-V lithium
coin cell battery.
Expansion bus specifications
The VxRail P Series, V Series, and S Series appliances support PCI express (PCIe)
generation 3 expansion cards, that can be installed on the system board by using
expansion card risers. These appliances support three types of expansion card risers.
The following table provides detailed information about the expansion card riser
specifications:
This table provides information about the expansion card riser configuration for VxRail
P Series, V Series, and S Series appliance.
Table 18 Expansion card riser specifications
Supported
VxRail config
Riser config.
and supported
risers
Slot
desc
PCIe slots
on riser 1
(Height
and
length)
Proc
conn
PCIe
slots on
riser 2
(Height
and
length)
Proc
conn
PCIe
slots on
riser 3
(Height
and
length)
Proc conn
VxRail P Series
and S Series
appliances
Riser configuration
1 with or without
rear storage (1B
+2B)
Four x8
slots and
rear
storage
Slot 1: x8
full-height,
full length
Processor
1
Slot 4: x8
low profile,
half length
Processor
1
N/A
N/A
Slot 2: x8
full-height,
full length
Processor
1
Slot 3: x8
full-height,
half length
Processor
1
Technical specifications
28
VxRail Appliances on 14th Generation PowerEdge
P Series, V Series, and S Series Appliance Owner's Manual
