Figure 62. Installing the PERC riser board
Next steps
1.
.
2.
.
3. Follow the procedure listed in
After working inside the system
Drive cage
Removing the 3.5 inch drive cage
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION:
You must note the slot number of each drive and temporarily label them before removal so that you
can replace them in the same slots.
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in the
Before working inside your system
3.
.
4.
.
5.
.
6.
Remove the power distribution board
.
Steps
1. Using the Phillips #1 screwdriver, remove the 24 screws that secure the drive cage to the chassis.
2. Loosen 18 captive screws on the cage.
3. Lift the front/rear drive cage away from the enclosure.
58
Installing and removing enclosure components
