Figure 75. Rear intrusion switch removal
Next steps
Replace the rear intrusion switch
Installing the rear intrusion switch
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in the
Before working inside your system
3.
.
4.
5.
Steps
1. Align and slide the intrusion switch in the slot until it is firmly seated in the slot on the system.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Replace the screws to secure the switch bracket to the PDB module.
3. Connect the intrusion switch cable to the connector on the system board.
Installing and removing enclosure components
69