Dell EMC PowerEdge xe7100, Installation And Service Manual

Page: 57 / 89

Next steps
1. Install the PERC riser .
2. Connect the cables to the connectors on the PERC.
3.
Install the expander module .
4. Follow the procedure listed in After working inside the system .
.
Removing the PERC riser board
Prerequisites
1. Follow the safety guidelines listed in safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the expander module .
4. Remove the PERC card .
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the PERC riser board to the PERC riser.
2. Pull the PERC riser board from the riser.
Figure 61. Removing the PERC riser board
Next steps
Replace the PERC riser board .
Installing the PERC riser board
Prerequisites
1. Follow the safety guidelines listed in safety instructions .
2. Follow the procedure listed in the Before working inside your system .
Steps
1. Align and insert the PERC riser board into the riser bracket.
2. Tighten the two screws to secure the PERC riser board to the riser.
Installing and removing enclosure components 57