Table 5. Dimensions of the PowerEdge XE7100 enclosure
Xa
Xb
Y
Za
Zb
Zc
482 mm (18.97
inches)
434 mm (17.08
inches)
219.25 (8.63
inches)
48.5 mm (1.9
inches)
823.5 mm (32.42
inches)
871.5 mm (34.31
inches)
Chassis weight
Table 6. Chassis weight of the PowerEdge XE7100 enclosure with PowerEdge XE7440 and XE7420 sleds
System
Maximum weight (with all sleds and drives)
Chassis weight without sled
132.26 Kg (291.58 lb)
Chassis weight with half-width sled
(XE7420)
137.12 Kg (302.29 lb)
Chassis weight with full- width full-
height sled (XE7440).
140.93 Kg (310.69 lb)
Chassis weight with full- width low-
profile sled (XE7440)
142.81 Kg (341.84 lb)
PSU specifications
The PowerEdgeXE7100 enclosure supports two AC power supply units (PSUs).
Table 7. PSU specifications
PSU wattage
Class
Heat dissipation
(maximum)
Frequency Voltage
Maximum input
current
2400 W AC
Platinum
9000 BTU/hr
50/60 Hz
200-240 V AC,
autoranging
16 A
NOTE:
Heat dissipation is calculated using the PSU wattage rating.
NOTE:
This system is also designed to connect to the IT power systems with a phase to phase voltage not exceeding 240
V.
PSU redundancy
The PowerEdge XE7100 supports 1+1 redundancy mode.
●
In case of a single PSU failure on a fully loaded configuration in 1+1 redundancy mode, system performance may degrade due
to power capping.
●
Replace the faulty PSU for optimal performance and to resume the 1+1 redundancy mode.
Cooling specifications
The PowerEdge XE7100 chassis with two PowerEdge XE7420 nodes/sleds or one PowerEdge XE7440 node/sled has 18 fans.
These are divided into three fan zones (Chassis, Node_A, and Node_B), and each zone has six fans.
The chassis fans are single rotor fans, and sled fans are dual rotor fans.
For Half-Width (HW) sled, sled 1 is Node 1 and sled 2 is Node 2.
74
Technical specifications