Cluster and VMs
From the vCenter console, review the virtual machines created by CloudBuilder. You should see 11 VMs running with their
Status
indicating
Normal
.
Figure 51. Cluster and VMs
vSAN
About this task
Review the vSAN Disk Groups in vCenter by performing the following steps:
Steps
1
On the
Hosts and Clusters
tab, select the management cluster.
2
On the
Configure
tab, click
Disk Management
.
In the
Disk Groups
section, you should see each of your hosts in the management cluster and the disk groups.
NOTE:
In this example, there are two disk groups on each server with three disks in each group.
Figure 52. vSAN Disk Groups
NSX Manager
About this task
To verify that NSX Manager has been installed, perform the following steps:
82
Post-install validation
Summary of Contents for PowerEdge MX7000
